Hello again, all. If you've read my previous posts, you'll know that I'm working on doing an emulsion lift process for a project. But, I've run into a problem or two.
I purchased two cartridges of Polaroid 690 film ($30 >_< to use in my SX-70 Polaroid Land Camera. Going off of what I've learned, this should work. Surprise surprise though. The film won't go into my camera. My question to you all is; Is this even the right film, or, is possible to use a non-polaroid film for an emulsion lift?
Any help or advice would be greatly appreciated.
Thanks again,
-Pedra
I purchased two cartridges of Polaroid 690 film ($30 >_< to use in my SX-70 Polaroid Land Camera. Going off of what I've learned, this should work. Surprise surprise though. The film won't go into my camera. My question to you all is; Is this even the right film, or, is possible to use a non-polaroid film for an emulsion lift?
Any help or advice would be greatly appreciated.
Thanks again,
-Pedra