Safelights

Discussion in 'The Darkroom' started by oriecat, Nov 12, 2003.

  1. oriecat

    oriecat work in progress

    Joined:
    Jul 7, 2003
    Messages:
    3,118
    Likes Received:
    19
    Location:
    Portland OR USA
  2. voodoocat

    voodoocat ))<>(( Supporting Member

    Joined:
    May 15, 2003
    Messages:
    5,277
    Likes Received:
    17
    Location:
    Gilbert, AZ
    Can others edit my Photos:
    Photos NOT OK to edit
    That's the kind I use. I use it in a normal light fixture.
     
  3. ksmattfish

    ksmattfish Now 100% DC - not as cool as I once was, but still

    Joined:
    Aug 25, 2003
    Messages:
    7,021
    Likes Received:
    34
    Location:
    Lawrence, KS
    Can others edit my Photos:
    Photos NOT OK to edit
    To test your safe light place a coin on a sheet of paper and let it sit on your workspace for one minute. Develop normally. Can you see a whiter circle where the coin was? If so you are getting safe-light fogging. Check for five min too. If you don't see anything after five min, you know you are good.

    If you are getting fog, it may just be that your safe light is too close. Try it again after moving the safe light further from your work area.
     

Share This Page