MOREGONE
No longer a newbie, moving up!
- Joined
- Sep 13, 2012
- Messages
- 875
- Reaction score
- 195
- Location
- Tempe, AZ
- Can others edit my Photos
- Photos NOT OK to edit
A scenario I encountered and could not figure out. I feel like there is an obvious answer I just haven't realized.
The setup
YN-560 off camera with a 622n trigger (manual only)
MK-910 on top of another 622n trigger on camera set to TTL
How would I disable the on camera flash and keep using the other flash off camera? The flash on camera is using TTL pass through.
It is not on a group (A,B,C) since it is being triggered through the sending transceiver. I tried turning off the flash on the camera and the other flash stopped along with it. The transceiver was still on. I suppose I could have tried putting the flash on S2 since there was no pre flash coming from the manual YN560
But seems there should be a correct way to do this...?
The setup
YN-560 off camera with a 622n trigger (manual only)
MK-910 on top of another 622n trigger on camera set to TTL
How would I disable the on camera flash and keep using the other flash off camera? The flash on camera is using TTL pass through.
It is not on a group (A,B,C) since it is being triggered through the sending transceiver. I tried turning off the flash on the camera and the other flash stopped along with it. The transceiver was still on. I suppose I could have tried putting the flash on S2 since there was no pre flash coming from the manual YN560
But seems there should be a correct way to do this...?
Last edited: