surely.
paper:
http://adorama.com/catalog.tpl?op=details&sid=10595423648206344&sku=LOCP81025R
a wonderful paper. i can't get enough of it. it's graded, so you'll have to deal with that w/developers.
printed through tissue paper.
developers: two step bath. a soft developer (selectol soft) at a 1:5 or 6 dilution for 2:15 stand development; no agitation. then immediately to a hard developer (edwal ultra black) at 1:2 for 15 seconds agitated.
i use a running water stop bath. figure 5 changes of water or 1 minute.
a non hardening fixer. i use tf-4. w/tf-4; 30 seconds.
allow excess fixer to drip off.
straight to selenium toner 1:12 at 70f. agitate until you get an increased density in zone 0/1.
wash for 5 minutes.
drip dry.
put into copper toner. agitate until desired tone.
immediately wash. 5 minutes.
don't over dry it as it will curl if you do. it is otherwise a non curling fiber paper.
you will need to print this down because the copper will reduce density. figure a stop over your normal exposure.
any questions, post away.